|
|
RECESSED DRINK HOLDERPart #: 35-GH43W1 Holds mugs and insulated can holders and adjusts to hold smaller cans, bottles and glasses.
Our Price:
$3.49
|
BUNGEE DOCK LINESPart #: 253-AHDL4 Bungee cord is hidden inside the rope and acts as a built-in snubber. Two foam floats protect the boat from chafing. Sliding adjustment at both ends More...
List Price
$10.99
Our Price
$9.99
|
DOCK HARDWARE
K. Bolts to outside of dock. Uses 2" pipe to hold dock in place. Carriage bolt set “M” required for attaching.
I. Should be used with every Angle. Two required for each Angle. 1-1/2"L x 5"H.
H. One welded 1/2" tab. Use with Female T connector to attach fingers and ramps. 5"L x 5"H. Bolt set “N” required for joint.
G. Two welded 1/2" tabs. Bolts to side of dock to attach fingers and ramps. 5"L x 5"H.
F. Should be used for all cross supports. Each leg 2-1/2"L x 5"H.
D. Should be used with one of the outside corners. Each leg has elongated holes for easy fit and is 8-1/4"L x 5"H.
C. Use this corner at ends of fingers and docks. Ideal for swim floats and ski jump corners. Each leg is 10"L x 5"H.
B. One 1/2" welded tab. Use with a female outside corner to connect docks end to end. Joint requires 3/4" bolt set (N) or connector pin (O). Each leg More...
A. Two 1/2" welded tabs. Use with a male outside corner. Each leg is 10"L x 5"H.
